Accelerometer with EFM Processor and Dual RS232 Interfaces

  • 3695

We currently have 1 in stock.


This module contains an Analog Devices ADXL362 Accelerometer. The module also contains an EFM32ZG108 Gecko low power microcontroller and two RS232 serial ports allowing it to be daisy chained in a network. Pre-Programmed for use in an openHAB Home Automation system or can be Re-Programmed for other uses.



  • Analog Devices ADXL362 Accelerometer
    • Low Operating Power - 1.8µA at 100 Hz sample rate and 3.0µA at 400 Hz sample rate
    • Motion activated wake up mode 270nA
    • Standby current 10nA
    • High resolution: 1mg/LSB
    • Deep FIFO to minimize load on the microcontroller
  • +3.6V to +6V Input Voltage
  • EFM32ZG108 Gecko Microcontroller
    • ARM Cortex-M0+
    • Low Power Operation
    • 32KB Flash Memory
    • 4KB RAM
  • MAX3232 Dual RS232 Line Driver/Receiver
  • Two 4 Pin DF11 Right Angle Male Connectors each with Power and RS232
  • 6 Pin DF11 Right Angle Male Connector for Programming and Debug
  • Pre-Programmed with openHAB Item Firmware for Plug-and-Play
  • Pre-Programmed Firmware is Designed for Low Power Operation
  • May be Programmed with the Arduino IDE
  • Power management designed for very low standby power
  • Small Size:  20mm x 20mm (0.79" x 0.79")


  • Measure vibration of machines or most anything that moves
  • Motion enabled switches
  • Wireless and wired sensors
  • Home automation

Eagle Files
ADXL362 Data Sheet


We Also Recommend