Menu
Cart

Reflective Object Sensor with EFM Processor and Dual RS232 Interfaces

  • 1495


Description:

This module contains two QRE1113 Reflective Object Proximity Sensors. The QRE1113 has an Infrared LED and a Photo-Transistor. When an object gets near, enough light is reflected back to the photo-transistor which causes the output to change. The two sensors are 14mm or 0.55" apart allowing direction of movement to be detected. The LED may be switched off and on by the microcontroller and sampled at a lower rate to save power. 

The module also contains an EFM32ZG108 Gecko low power microcontroller and two RS232 serial ports allowing it to be daisy chained in a network. Pre-Programmed for use in an openHAB Home Automation system or can be Re-Programmed for other uses.

Features:

  • Two QRE1113 Reflective Object Sensors
  • LED Power Enable to allow low standby power
  • +3.6V to +6V Input Voltage
  • EFM32ZG108 Gecko Microcontroller
    • ARM Cortex-M0+
    • Low Power Operation
    • 32KB Flash Memory
    • 4KB RAM
  • Small Size: PCB is 20mm x 24mm (0.79" x 0.95")
  • MAX3232 Dual RS232 Line Driver/Receiver
  • Two 4 Pin DF11 Right Angle Male Connectors each with Power and RS232
  • 6 Pin DF11 Right Angle Male Connector for Programming and Debug
  • Pre-Programmed with openHAB Item Firmware for Plug-and-Play
  • May be Programmed with the Arduino IDE 

Documents:
Schematic
Eagle Files
QRE1113 Reflective Object Sensor Data Sheet



 


We Also Recommend