Hall Effect Current Sensor with DF11 I/O Connector

  • 1195


This DF11-10 add on module contains an Allegro ACS716 Hall Effect Current Sensor. This module allows accurate measurement of AC or DC current. The current is measured and the ACS716 outputs a voltage that is proportional to the current.


  •     Allegro ACS716 Hall Effect Current Sensor
    • Precise AC or DC Current Sensing
    • 1mΩ primary conductor resistance
    • Low-offset linear Hall Effect sensor
    • Copper conduction path
    • High isolation voltage 3000 VAC
    • Working voltage up to 277 VAC
    • 3µs output rise time response to step input current
    • 100mV/Amp Sensitivity
    • ±7.5A Optimized Accuracy Range
  • +3.0V to +3.6V Input Voltage
  • Power management designed for very low standby power
  • Small Size: PCB is 20mm x 20mm (0.79" x 0.79")
  • Connector Options:
    • 10 Pin DF11 Male Connector to allow installation on an Engimusing Processor with DF11-10 I/O
    • 4 Pin DF11 Right Angle Male Connector for cable connection
  • Designed for low power operation with Engimusing Processors


  • Home Automation
  • Motor Control
  • Load Detection and Management
  • Fault Protection

Eagle Files
ACS716 Hall Effect Current Sensor Data Sheet




We Also Recommend